This is MPPNP: multi-zone post-processing network.
  (c) 2008 Marco Pignatari, Falk Herwig,
      Michael Bennett, Raphael Hirschi and the
      NuGrid collaboration.

 Input files read ...
 vital: false species=L   1
 vital: false species=G   1
 vital: false species=G  63
 vital: false species=LI  6
 vital: false species=BE  9
 vital: false species=B  10
 nvar rnetw2007        1088
 time for setting reactions false  0.13202300000000022      seconds
 There are        34999  models to be processed. Now building pp-grid ...
 finished IABUNI
 Broadcasting data to slaves...
 Broadcasting integers ...
 Broadcasting sp reals...
 Broadcasting dp reals...
 Broadcasting characters...
 Broadcasting logicals...
 cycle, time step /yrs:        84001   1.1573669127158709E-006
PRE-DIFFUSION:   0.36499D+02  0.10000D+011521
POST-DIFFUSION:   0.36499D+02  0.14304D-011549
 issues with mass conservation:   1.4303922657007528E-002        1549
 restart the simulation with iolevel=3.
 careful at the diffusion subroutine! 
--------------------------------------------------------------------------
mpirun has exited due to process rank 0 with PID 66896 on
node node2c09 exiting improperly. There are three reasons this could occur:

1. this process did not call "init" before exiting, but others in
the job did. This can cause a job to hang indefinitely while it waits
for all processes to call "init". By rule, if one process calls "init",
then ALL processes must call "init" prior to termination.

2. this process called "init", but exited without calling "finalize".
By rule, all processes that call "init" MUST call "finalize" prior to
exiting or it will be considered an "abnormal termination"

3. this process called "MPI_Abort" or "orte_abort" and the mca parameter
orte_create_session_dirs is set to false. In this case, the run-time cannot
detect that the abort call was an abnormal termination. Hence, the only
error message you will receive is this one.

This may have caused other processes in the application to be
terminated by signals sent by mpirun (as reported here).

You can avoid this message by specifying -quiet on the mpirun command line.

--------------------------------------------------------------------------